Scaffoldboro6
Well-known member
- Joined
- Sep 1, 2014
- Messages
- 56
- Reaction score
- 0
Ive been asked to supply a risk and method Statement for an impact wrench has anyone else had to do this and does anyone have a copy just for file please ?
Its not hard - all the data you need to compile it can be found in the manufactures data sheets & the free on line info from the hse website concerning havs & noise and just throw on a copy of the nasc statement reguarding their use & your own test sheet showing compliance to their recommendations - hey presto done - i could send you a copy of ours but tbh think you should do your own
Scaffoldboro will PM you tomorrow mate
---------- Post added at 09:50 PM ---------- Previous post was at 09:47 PM ----------
think you might be on the wrong thread brother :laugh::laugh:,
hows things mate hope your still busy ?