Bigtone
Well-known member
Before all the lube jokes start I'm not looking to lube up some poor labourers ring
Recently started my own firm a few months ago things are going better than expected problem is lubing up fittings has become quite time consuming if been using a brush and engine oil and winding them up and down.
I know many firms throw all the fittings in a bath and use scaffeze which I personally think is a load of ****.
In the old days my guv used to use hydraulic fluid that was just messy. Also a couple I know used a oil and diesel mix.
What are the preferred methods some of the firms/owners on here use
Sent from my iPad using Tapatalk
Recently started my own firm a few months ago things are going better than expected problem is lubing up fittings has become quite time consuming if been using a brush and engine oil and winding them up and down.
I know many firms throw all the fittings in a bath and use scaffeze which I personally think is a load of ****.
In the old days my guv used to use hydraulic fluid that was just messy. Also a couple I know used a oil and diesel mix.
What are the preferred methods some of the firms/owners on here use
Sent from my iPad using Tapatalk